Discontinued JCC Ultimo Range quad recessed ceiling plate in silver and white — 145 units of new-old-stock surplus, held ex-warehouse Leicester, UK. Specification-matched four-aperture plate for recessing JCC Ultimo luminaires into a plasterboard ceiling.
Held as UK stock, ex-warehouse Leicester. This SKU is one line within the JCC whole-lot commercial-lighting parcel (~8,585 units, GBP 8,500 ex-VAT for the entire lot), listed here for reference only. It is not sold separately; the parcel is supplied as a single lot, to trade.
Box-label photo evidence — JC87011 quad recessed ceiling plate in silver and white finishes.
The JCC JC87011 is the quad recessed ceiling plate from JCC's Ultimo Range — a long four-aperture mounting frame that recesses a row of four Ultimo downlights or spotlights flush into a plasterboard or suspended ceiling. Instead of cutting and finishing four separate holes and trimming each fitting individually, the installer forms one linear aperture, drops the plate in, and mounts the luminaires into its pre-set spacings. The result is a clean, factory-aligned run of four heads with consistent centres and a single continuous trim. The plate does the architectural work: it sets the aperture geometry, carries the fittings, and gives the ceiling a finished line. Because the apertures and spring-clip fixings are dimensioned to JCC's own Ultimo heads, it is a specification-matched part that a generic plate will not replace.
This holding is genuine new-old-stock (NOS) surplus: 145 unused plates carried over from JCC distribution, split 49 in silver and 96 in white so an installer can match the trim to either a contemporary or a neutral ceiling. Each plate measures roughly 92 × 27 × 7 cm and weighs about 1.7–1.8 kg. The stock is held ex-warehouse in Leicester, United Kingdom, and photographed against its box labels for the buyer pack. As passive mounting hardware with no lamp and no driver, the JC87011 sits entirely outside the lamp bans and Ecodesign rules that affect some lighting stock — there is nothing here that a UK or export buyer cannot legally hold, resell or fit.
For the trade, the value is in specification matching against a discontinued range. Where a retail chain, gallery, hotel or commercial office already runs recessed Ultimo lighting and needs to extend a bank of downlights, refit a remodelled area, or replace a damaged plate, the original quad plate is the only component that preserves the aperture spacing and the flush trim line. JCC no longer makes them, so a contractor holding the correct plates has no direct current-market alternative to compete with — the quality that makes discontinued JCC architectural hardware a durable resale line rather than ordinary clearance. Quad plates are also a natural pairing sale alongside the single plates, brackets, drop rods and the Ultimo downlights carried elsewhere in this parcel, letting a reseller supply a complete recessed-scheme kit from one source.
Commercially, the JC87011 is offered as UK surplus / liquidation stock for trade and resale only. It is not a retail product and is not sold as a stand-alone line: it forms part of Austral Prime's JCC commercial lighting whole-lot bulk package — roughly 8,585 units across infrastructure, fittings and architectural hardware, supplied as a single lot for GBP 8,500 (ex-VAT) ex-warehouse Leicester. The whole-lot structure is deliberate: it lets one buyer take the entire discontinued JCC range at clearance economics, then place the individual lines — ceiling plates, downlights, brackets, drop rods — into their own maintenance, refurbishment, retrofit or export channels at trade margin. UK supply is subject to VAT at the standard rate (reclaimable by VAT-registered buyers); exports removed from the UK may be zero-rated on valid evidence.
In service the recessed ceiling plate remains fully relevant. Flush four-head runs are still specified wherever a clean architectural ceiling and controlled accent lighting are wanted — retail display, reception and lobby joinery, gallery and museum spaces, showrooms and hospitality fit-outs. Many of those installations have since been re-lamped from halogen or metal-halide to modern LED Ultimo heads, but the ceiling plate is unaffected: the recessing hardware outlives several generations of luminaire and lamp. Holding the correct quad plates lets a maintenance contractor keep those recessed banks aligned and serviceable without proposing a costly full ceiling re-cut to the client.
That is the quiet strength of discontinued-range hardware as a resale category: demand is inelastic and supply is finite. This JC87011 holding is ex-catalogue, ex-distribution closeout inventory — the kind of surplus that rarely reaches the open market in usable quantity, let alone across two finishes. Taken inside the JCC whole-lot package, it gives a wholesaler a defensible, low-competition line to list against searches such as ‘discontinued JCC quad ceiling plate’ or ‘Ultimo recessed plate spares’, while the bulk clearance economics protect resale margin. For businesses running a circular or refurbishment model, keeping legacy recessed lighting in service is also a clean sustainability story to take to end clients — repair and extend rather than strip out and landfill.
Buyers who typically move stock like this include electrical wholesalers, lighting refurbishers, JCC-system maintenance specialists, pallet and job-lot liquidation traders, and export resellers shipping into the EU or Australian markets. If the JC87011 or the wider JCC architectural-hardware group fits your book, the full per-SKU manifest — quantities, locations, dimensions and box-label photography — is available on enquiry. Title and risk pass on dispatch from Leicester; buyers collect or arrange their own freight. Sale is ‘as is’, on documentary (not third-party audited) evidence, with photographs supplied ahead of commitment.
The JC87011 quad recessed ceiling plate is supplied as part of the JCC whole-lot parcel. Register interest in the lot or request the full trade manifest and photographs.